Quick Start Guide

Getting Started
4
Getting Started
The battery comes pre-installed in the camcorder, however you must
remove the protective film on the battery before use.
To properly connect the battery:
1 Slide the back battery cover off.
2 Remove the battery.
3 Pull the film off.
4 Reinsert the battery, making sure it is lined-up with the correct
polarity marks.
5 Close the battery cover.
To insert the SD™ Card (optional):
1 Flip open the SD™ Card cover.
2 Insert the SD™ Card into the slot until it locks in place.
3 Once inserted, close the SD™ Card cover.
To remove the
SD™ Card, press
inward to release
it. When the card
pops out, grasp
it and pull it
Li-ion battery
straight out.
GMAA00217011.book Page 4 Friday, March 26, 2010 10:53 AM