Manual

Using the Remote with VCR or Cable TV Converter
• To control a TOSHIBA VCR, first set the TV/CABLENCR switch to "VCR" position. The buttons shown below will then
control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 9.
• To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 9. The shaded buttons can be used to control the cable TV converter.
Set the TV/CABLENCR switch to "CABLE" position whenever you control the cable "IV converter.
Aim at the VCR or cable TV converter
m
m
m
Channel Number buttons
Press the numbers
desired for direct access.
TV/CABLENCR
"CABLE': To control the
cable box
"VCR': To control the VCR
TV/VCR button
Press to select the TV mode to
view one program while
recording another program.
REC (record) button
Press tb start recording.
SLOW button
Press to view a slow-motion
picture in playback mode.
PAUSE button
Press to freeze the picture
during playback or recording.
Press again to release.
RECALL MUTE
@ @
®
POWER button
Press the button to tom the
VCR (or converter) on.
Press again to turn off.
ENTER button
Some VCR's and Cable TV
converters require "ENT" to
change channel number.
•/• button
Press • to select next higher
channel.
Press • to select next lower
channel.
STOP button
Press to stop the tape.
PLAY
Press to begin tape playback.
RF(fast forward) button
Press to rapidly advance the tape.
In playback mode_.press to view
the picture moving rapidly in
forward direction.
REW (rewind) button
Press to rewind the tape.
In playback mode, press to
view picture moving rapidly in
reverse.
B