Manual

Programming the Remote Control

• This Remote Control is preprogrammed to operate TOSHIBA VCR's.

• To use VCR's other than Toshiba models (or cable converter), perform the following procedures before operating.

FAV CH WMOEC

_"_ Ci3 C3D

REC TV/VCR STOP PLAY

QD _-1Ci3 C!3

StOW PAUSE REW FF

CE3QD 13_ r'_

TOSHIBA

For future reference, write the code

you used.

VCR CODE:

CABLE CODE:

1 Refer to the "VCR code table = (or "Cable TV converter code table')

on pages 10 and 11 to find the code number that corresponds to the

brand name of your VCR (or converter).

If more than one number is listed, try each one separately until you

find the one that works.

Set the TVICABLEIVCR switch to "VCR" (or "CABLE').

Hold down RECALL while pressing the Number buttons for the three

digit code number for your brand of VCR (or converter).

4 Point the Remote Control at the VCR (or at the converter) and press

POWER to test the code number.

-If the right number was entered, the VCR (or the converter) should

turn off.

-If the VCR (or the converter) does not respond to the Remote

Control, repeat steps 1 to 4 with another code number. 1_

Notes: €°

• You have to reprogram the Remote Control when you change its •

batteries.

• Some newer VCR's are capable of working on either of two remote *"

codes. These VCR's have a switch labeled "VCR1/VCR2". €TM

If your VCR has this kind of switch, and does not respond to all the

code numbers for your VCR brand name, set the switch to another

position ('VCRI" or "VCR2") and reprogram the Remote Control.

€

€ll

.€