Manual

Programming Channel Memory
The channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL • or • button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired
channels.
O
-/+ POWER
ADV 3
MENU
MENU -
ADV T--
cCAPT RECALL F,OI, v_
-O TVNtDO MUT E
© ©
STOP SOURCE PLAY PIP
CK2)
REC TW_CR REW FF
®O@®
STILL LOCATE SWAP
TOSHIBA
--POWER
ADV •
Press POWER to turn on the TV.
Press MENU repeatedly until the Setup
menu is displayed on the screen.
Press ADV repeatedly until "l-V/CABLE" is
displayed in magenta.
4
Press- or + until the mode that corre-
sponds to you rTV signal system is displayed
in magenta.
TV: TV broadcastssignals.
(VHFchannels2through 13and UHF
channels 14through 69)
CABLE: CableTV signals.
(Cable channels 1th rough 125)
1
2
Press MENU repeatedly until the Setup
menu is displayed on the sc:reen.
Press ADV repeatedly until "CH PRO-
GRAM" is displayed in magenta.
3
Press- or + to start channel program-
ming.
The TV will automatically cycle through
all the TV or CABLE channels depending
on the mode selected, and store active
channels in the channel memory.
4 When channel programming is complete,
you will see the message at the right.
TWCABLE [ TV ]CA£LE
TO SELECT ITEM PUSH _DV
TO CONTROL PUSH - +
[TViCABLE
TO SELECT ITEM PUSH IIDV
TO CONTROL PUSF - *
OH PROGRAM
TO SELECT ITEM PUSH ADV
TO CONTROL PUSH - +
CH PROGFIAM
TV
4!,
CH PROGIqAMMI NG
COMPLETED
TV
24
5 Press CHANNEL • or • to make sure the c:qannel programming has
been done properly.
16