User manual

June 2005 © TOSHIBA TEC e-STUDIO281c/351c/451c FIRMWARE UPDATING

6 - 3

PWA-DWNLD-350-JIG2 (48MB)

Fig.6-1 Jig board: PWA-DWNLD-350-JIG2 (48 MB)

Important:

• To perform update, two download jigs (PWA-DWNLD-350-JIG2) are needed.

• The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on

the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the

data to these Flash ROMs. Refer to the following to write the data.

 P.6-13 "6.1.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"

K-PWA-DLM-320

Fig.6-2 Jig board: K-PWA-DLM-320

Important:

Pay attention to the direction of the ROM.

ROM4

ROM5

ROM6

ROM1

ROM2

ROM3

Connector

(

for SYS board

connection

)

Connector

(

for ROM writer

adapter connection

)

Connector Mark for ROM

installation direction

ROM

LED