Telephone User Manual

Station Apparatus
Cordless Telephone Installation
Strata CTX I&M 06/04 11-37
Station Apparatus
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your telephone directly on a wall. Before
mounting your telephone, consider the following:
• Select a location away from electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the wall.
• Make sure the wall material is capable of supporting the weight of the base unit.
• Use #10 screws with anchoring devices suitable for the wall.
³ To wall mount the base unit
1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of
an inch between the wall and screw heads for mounting the telephone
(shown right).
2. Plug and secure the AC adapter cord by following Steps 2 and 3 of
the “Standard Wall Plate Mounting” on page 36.
3. Plug one end of the telephone line cord into the LINE jack on the base
unit. Optionally, plug one end of a Strata DKT telephone into the
PHONE jack. Then place the telephone cord(s) inside the molded
channel(s) on the bottom of the wall mount stand.
4. Place the base unit on the posts of the wall screws and push
down until it’s firmly seated.
5. Plug the other end of the telephone cord into a telephone wall
jack.
6. Plug the AC adapter into a standard 120VAC wall outlet by
following Step 7 of the Standard Wall Plate Mounting.