User Guide

Station Apparatus
Cordless Telephone Installation
Strata CTX I&M 06/04 11-39
Station Apparatus
Step 7: Raise the Base Unit Antenna
³ Before using your handset, raise the base unit antenna to the vertical position.
Step 8: Install Handset Battery Pack
DKT2204-CT
1. Remove the battery cover by pressing the latch and sliding the cover down and off the handset.
2. Slide the battery pack down into the handset (shown right).
3. Securely close the battery compartment cover by sliding it
up until it snaps into place.
DKT2304-CT
1. Remove the battery cover by pressing the latch and sliding
the cover down and off the handset.
2. Connect the battery pack connector observing correct
polarity to the jack inside the battery compartment. Do not
exert any force on this connection. It could cause damage
to the battery or handset. Once you are certain that you
have made a good connection, then insert the battery pack
into the battery compartment. Do not pinch the wires
(shown right).
3. Securely close the battery compartment cover by sliding it
up until it snaps into place.
CAUTION! Rechargeable Nickel-Metal-Hydride batteries must be disposed
of properly.
4.
Step 9: Charge Batteries for First Time
Important! Before using your handset, the battery must be continuously charged for five hours.
1. Place the handset in the charging unit (shown at right).
2. Ensure that the
CHARGE LED lights. If it does not, make sure that
the AC adapter is plugged in and that the handset is making good
contact with the charging unit contacts.
DKT2204-CT Charging
Unit (pictured)