Installation guide

Connect your TV and the antenna to this recorder for recording and to view broadcast programs on the

TV.

Disconnect the antenna cable from your TV, and connect it to the RF IN

(FROM ANT.) terminal on the recorder.

Using the supplied coaxial cable of this recorder, connect the RF OUT (TO

TV) terminal to the TV.

_ VHF/UHF antenna

Antenna cable (not supplied)

To RF IN (FROM ANT.)

To RF OUT (TO TV) _ Coaxial cable supplied)

To antenna inpu_

Antenna splitter (not supplied) _ _ //

Types of an antenna terminal may vary _ I / /

depending on the TV. Iv _J / /

Check the type on your TV, and connect _ II_! / /

properly using either method as shown. _'_ '_1 / l

For connecting to a cable box or a satellite system, see _ page 22 to 24.

Note

• This connection insures accessibility of broadcast signals to your TV only. Unlike a VCR, you can not assign channel 3 or 4

for playback of this recorder, because an antenna input only passes through in the recorder. You must connect this recorder

to a video input of your TV to enjoy playback picture from this recorder. (See the next page.)