Installation guide

If your TV has component video inputs, you can obtain pictures in better quality.

PROOMPONENTOUTPUT

_.nly video signals are output from_

I the COMPONENT OUTPUTjacks. I

I (Audiosignals are not output.)

I Toobtainthe sound, connect an audio )

_stem tothe audiooutput jacks,f

TV or monitor equipped with

component video (INTERLACED/

PROGRESSIVE) inputs

(not supplied)

To PRvideo input

To P8video input

ToY video input

• Component video outputs/inputs

Some TVs or monitors are equipped with component

video inputs. Connecting to these inputs allows you to

enjoy higher quality picture playback.

Actual labels for component video inputs may vary

depending on the TV manufacturer. (ex.Y, R-Y, R-B or

Y, CB, CR)

In some TVs or monitors, the color levels of the

playback picture may be reduced slightly or the tint

may change. In such a case, adjust the TV or monitor

for optimum performance.

To switch the output signal (Progressive/Interlaced)

PROGRESSIVEPress PROGRESSIVE on the remote control.

The output signal alternates between

component progressive and component

interlaced.

• Make the following setting.

On-screen display Select Page

"Audio out select Analog 2ch" _ page 38

Notes

• Refer to the owner's manual for the TV to be connected to this recorder for more information concerning an audio system.

• If you place the recorder near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the recorder

away from the tuner and radio.

• The output sound of the recorder has a wide dynamic range. Be sure to adjust the audio amplifier's volume to a moderate

listening level. Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.

• Turn off the amplifier before you connect or disconnect the recorder's power cord. If you leave the amplifier power on, the

speakers may be damaged.