DVD Video Recorder Owner's Manual

138
Function Setup
EN
Audio setting (cont’d)
A
Settings for PCM (Default : 48kHz)
• Using [K / L], select a setting. Press [ENTER].
Your setting will be activated.
48kHz : If your amplifier/decoder is NOT compatible with 96kHz PCM,
select “48kHz”. 96kHz sound will be output in 48kHz.
96kHz : If your amplifier/decoder is compatible with 96kHz PCM, select
“96kHz”. 96kHz sound will be output.
Note
When playing disc with copyright protection
• Even if you select “96kHz”, the sound will be down sampled at 48kHz.
B
Settings for Dolby Digital (Default : Stream)
• Using [K / L], select a setting. Press [ENTER].
Your setting will be activated.
PCM : Convert the Dolby Digital into PCM(2 channel).
When your amplifier/decoder is NOT compatible with Dolby
Digital, set to “PCM”.
Stream : Outputs Dolby Digital signals.
When your amplifier/decoder is compatible with Dolby Digital,
set to “Stream”.
Note
When playing a DVD-RW disc recorded in VR mode
• If the audio source on a disc is Dolby Digital format, set “Dolby Digital” to
“PCM” so that you can switch to main (L), sub audio (R), or a mix of both (L/
R) with your amplifier/decoder.
Digital Out - PCM
96kHz
48kHz
Digital Out - Dolby Digital
Stream
PCM
Functionsetup_CD.indd 138Functionsetup_CD.indd 138 2006/02/16 21:05:342006/02/16 21:05:34