Operator's Manual

185
This function attaches a sub-ad-
dress to the standard destina-
tion address in the event the re-
mote party requires one.
Three types of sub-addresses
can be used (SUB, SEP, and
PWD); or any combination of
two or three types can be used.
After selecting the desired
types, the transmission to follow
will be sent to the desired ad-
dress using the designated sub-
address.
You can activate this option
while programming an Abbrevi-
ated Dial Number (page 70) or
One Touch Dial Key (page 77) if
communication with a certain re-
mote party always requires this
option.
If you activate this option using
both the Abbreviated Dial Num-
ber (or One Touch Dial Key)
setting and using this procedure
for the same destination, this
operation will take precedence
over the pre-programmed set-
ting in Abbreviated Dial or One
Touch Dial.
NOTE:
For more information on
when to use SUB/SEP/PWD,
refer to page 75. If you des-
ignate an erroneous or un-
necessary sub-address, the
communication will result in
an error.
Turn the Flip Panel to the “50-
73” view to select the desired
Function Key.
Press:
Load the document face down
in the Document Tray (see page
88).
Adjust the resolution and con-
trast if desired (see page 89).
Select one of the following op-
tions from the menu.
To select SUB, press:
Go to Step 4.
To select SEP, press:
Go to Step 5.
To select PWD, press:
Go to Step 6.
To complete this procedure,
press:
Go to Step 7.
Enter the required SUB address
(max. 20 digits), then press:
The display returns to the
screen at the bottom of Step 2.
You may continue from Step 3
and enter another sub-address
of a different type. To complete
your sub-address entry, select
option “1.COMPLETE” in Step
3.
Dialing with Sub-Address
Load the Document
1
Select the Option
3
Enter the SUB
Address
4
Display the SUB
ADDRESS COMM
Menu
2
MAY-17-00 WED11:13
RESIDUAL MEMORY 100%
ENTER TEL NUMBER
SUB ADDRESS COMM.
1.COMPLETE
2.SUB
3.SEP
4.PWD
SUB ADDRESS COMM.
SUB =(MAX20)