Operation Manual

32
Recording a TV program
To record a TV program currently being broadcast, follow the procedures of this chapter.
Recording
DVD-RAM DVD-RW
DVD-R
ENTER
PLAYSTOP PAUSE
REC
TV/VIDEO CHANNEL VOLUME
LIBRARY
REC MENU EDIT MENU
CONTENT MENU
V-REMOTE
ANGLE
OPEN/CLOSE
SUBTITLE
AUDIO CHANNEL
REC
REMAIN
DIMMER FL SELECT ZOOM P in P
TIME BAR CHP DIVIDE DISPLAY
INPUT SELECT
PROGRESSIVE
QUICK MENU
INSTANT SKIPINSTANT REPLAY
TOP MENU
MENU RETURN
DVD
TV
TIMESLIP
F
R
A
M
E
/
A
D
J
U
S
T
P
I
C
T
U
R
E
S
E
A
R
C
H
S
K
I
P
S
L
O
W
INPUT SELECT
1
Press INPUT SELECT repeatedly to select a
recording source.
Each time you press the button, the indicator alternates.
Ch-: To record a TV program or CATV program.
L-1: To record a source connected to the INPUT1
jacks on the rear panel (
page 37).
L-2: To record a source connected to the INPUT2
jacks on the front panel (
page 37).
L-3: To record a source connected to the INPUT3
jacks on the rear panel (
page 37).
To record a program from a connected cable box or
satellite receiver, set the channel to “Ch-3”, “Ch-4”, or
“L-1” according to the connection (the same as
page 39 on “INSTALLATION GUIDE”).
Select the proper channel on the cable box or satellite
receiver to receive the desired program.
Preparation
• Load a DVD-RAM/R/RW disc into the recorder.
- Load a disc which has sufficient space available to record the program.
- Make sure the loaded disc is not write-protected.
• If you record on a DVD-R or a DVD-RW disc, set “DVD Video Compatibility” (
page 132) to “Main” or “SAP.” In
DVD-R/RW recording, “Off” setting is regarded as “SAP.”
• If you record on a DVD-R or DVD-RW disc, set “Aspect Ratio (Video mode)” (
page 132) according to recording
sources.
INPUT SELECT