Manual

Hardware for the Equium 8100D
3-8 Equium 8100D/M
Equium 8100D/M – 03CHAP.doc – ENGLISH – Printed on 23/sep/01 as 03_800UK
• If you are installing the device in theinternal expansion bay, fasten
the new device to the chassis using four screws.
10. Connect the new device to the IDE connector.
11. Connect the new device to the power supply connector.
12. Replace the case panels and front bezel, as required.
Configuring the new device
Before you can use a new device, it must be configured. Your Microsoft
operating system may be able to configure the new device automatically
when you reboot the computer.
If the device is not automatically configured by the operating system, you
may need to use the BIOS Setup program to manually configure the
device.
To determine which configuration settings to use for the new device, refer
to the documentation that came with the device.
Write down the device type and settings of your existing devices for future
reference, or in case you inadvertently change this information while
manually configuring the new device.
Partitioning and formatting a new hard disk drive
Before you can use the new hard disk drive, it must be partitioned and
formatted. Follow the instructions provided by the manufacturer.
Take care not to accidentally format your existing drive. Formatting
destroys all data on a drive.