Owner's manual
Table Of Contents
- User’s Manual
- Table of Contents
- Preface
- Chapter 1 - Features, Utilities and Options
- Chapter 2 - The Grand Tour
- Chapter 3 - Getting Started
- Chapter 4 - Operating Basics
- Using the TouchPad/Dual Mode Pad
- Dual Mode Pad Button function (Dual Mode Pad is provided with some models)
- Using the Web Camera (depending on the model purchased)
- Using the internal modem
- LAN
- Wireless LAN
- Using optical disc drives
- Writing CDs/DVDs on a DVD Super Multi drive or HD DVD-ROM drive supporting double layer disc recording
- Writing CDs/DVDs/HD DVDs on a HD DVD-R drive
- Using Ulead DVD MovieFactory® for TOSHIBA
- TOSHIBA Disc Creator
- Media Care
- TV-Out & HDMI
- Setting up more than one display
- Cleaning the computer
- Moving the computer
- Chapter 5 - The Keyboard
- Chapter 6 - Power and Power-Up Modes
- Chapter 7 - HW Setup
- Chapter 8 - Optional Devices
- Chapter 9 - Troubleshooting
- Chapter 10 - Disclaimers
- Appendix A - Specifications
- Appendix B - Display Modes
- Appendix C - AC Power Cord and Connectors
- Appendix D - If your computer is stolen
- Glossary
User’s Manual 3-3
A210
Opening the display
The display panel can be rotated in a wide range of angles for
optimal viewing.
1. Slide the display latch on the front of the computer.
Opening the display
2. Lift the panel up and adjust it to the best viewing angle for you.
Turning on the power
This section describes how to turn on the power.
1. If a USB floppy disk drive is connected, make sure the drive is empty - if a
disk is in the drive, press the eject button to remove it.
2. Open the display panel.
3. Press the computer’s power button and then release it.
Turning on the power
Use reasonable care when opening and closing the display panel.
Opening it vigorously or slamming it shut could damage the computer.
After you turn on the power for the first time, do not turn it off until you have
set up the operating system. Refer to the section Starting up for the first
time in this chapter.