Owner's manual
Table Of Contents
- User’s Manual
- Table of Contents
- Preface
- Chapter 1 - Features, Utilities and Options
- Chapter 2 - The Grand Tour
- Chapter 3 - Getting Started
- Chapter 4 - Operating Basics
- Using the TouchPad/Dual Mode Pad
- Dual Mode Pad Button function (Dual Mode Pad is provided with some models)
- Using the Web Camera (depending on the model purchased)
- Using the internal modem
- LAN
- Wireless LAN
- Using optical disc drives
- Writing CDs/DVDs on a DVD Super Multi drive or HD DVD-ROM drive supporting double layer disc recording
- Writing CDs/DVDs/HD DVDs on a HD DVD-R drive
- Using Ulead DVD MovieFactory® for TOSHIBA
- TOSHIBA Disc Creator
- Media Care
- TV-Out & HDMI
- Setting up more than one display
- Cleaning the computer
- Moving the computer
- Chapter 5 - The Keyboard
- Chapter 6 - Power and Power-Up Modes
- Chapter 7 - HW Setup
- Chapter 8 - Optional Devices
- Chapter 9 - Troubleshooting
- Chapter 10 - Disclaimers
- Appendix A - Specifications
- Appendix B - Display Modes
- Appendix C - AC Power Cord and Connectors
- Appendix D - If your computer is stolen
- Glossary
User’s Manual 4-9
A210
Connecting the LAN cable
If you are using Ethernet LAN (10 Mbps, 10BASE-T), you can connect
using either a CAT5 or a CAT3 cable.
If you are using 100BASE-TX Fast Ethernet, you must connect using a
CAT5 cable.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices
connected to the computer.
2. Plug one end of the cable into the LAN jack. Press gently until you hear
the latch click into place.
Connecting the LAN cable
3. Plug the other end of the cable into a LAN hub connec tor. Check with
your LAN administrator before connecting to a hub.
Disconnecting the LAN cable
To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer’s LAN jack and pull
out the connector.
2. Disconnect the cable from the LAN hub in the same manner.
Check with your LAN administrator before disconnecting from the hub.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer’s default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.