Instruction Manual

User’s Manual 9-9
Troubleshooting
Sound system
Pointing device
If you are using a USB mouse, also refer to the USB section in this chapter
and to your mouse documentation.
TouchPad/Dual Mode Pad
Monitor goes into
panning mode
Check your monitor specification. It might not
support the selected resolution and refresh rate.
The resolution on the monitor might go into
panning mode when wide screen resolution is
selected. Refer to Appendix B, Display Modes.
Problem Procedure
Problem Procedure
No sound is heard Adjust the volume control dial.
Check the software volume settings.
If appropriate, make sure the headphone
connection is secure. Check Windows Device
Manager and ensure the sound function is
enabled and that settings for I/O address,
interrupt level and DMA are correct for your
software and do not conflict with other hardware
devices that you have connected to the
computer.
If problems persist, contact your dealer.
Problem Procedure
On-screen pointer does
not respond to Pad
operation
The system might be busy. If the pointer is
shaped as an hourglass, wait for it to resume its
normal shape and try again to move it. You may
also press Fn + F9 to enable the TouchPad/Dual
Mode Pad and then try again to move it.
Double-tapping does
not work
Try changing the double-click speed setting in the
mouse control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Buttons tab.
3. Set the double-click speed as instructed and
click OK.