DVD VCR Combo User Manual

Introduction

NOTES: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the

antenna to the DVD/VCR properly.

• For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use

of an outdoor type antenna is required.

• If you are not sure about the connection, please refer to qualified service personnel.

If you are using an antenna system, follow these instructions. If you are using a Cable TV subscriber, skip

ahead to page 18 for the proper connections.

ANTENNA TO DVD/VCR CONNECTION

The DVD/VCR must be connected “between” the antenna and the TV. First, disconnect the antenna from the TV

and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connect-

ing an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection

diagram.

If both UHF and VHF antennas have 300 ohm twin lead (flat) wires,

use a combiner having two 300 ohm inputs and one 75 ohm output.

NOTE:

Antenna connections

Combination UHF/VHF antenna with 75 ohm coaxial cable

Combination UHF/VHF antenna with 300 ohm twin lead (flat) wire

Separate UHF and VHF antennas

DVD/VCR

75 ohm coaxial cable

2J40101A P12-22 3/4/06, 10:43 AM16