Owner manual

8
Controls
While all the necessary adjustments and controls for the television are made using the remote control,
the buttons on the television may be used for some functions.
RED LED - Standby
GREEN LED - Power on
Control panel
Switching on
If the RED LED is not lit, check that the mains plug is
connected to the power supply and press
1
on the
remote control; it may take a few moments. The GREEN
LED will be lit.
To put the television into Standby, press
1
on the remote
control. To view the television, press
1
again. The picture
may take a few seconds to appear.
NOTE:
• Putting the television into standby mode will reduce
energy consumption, but will still draw some power.
• The TV will automatically turn itself o after
approximately 15 minutes if it is tuned to a vacant
channel or a station that completes its broadcast for
the day. This function does not work in external input
or Blue screen O mode.
Using the menu system
Press MENU on the remote control to display the menu.
The menu appears as a list of four topics. As each symbol
is selected by pressing
C
or
c
on the remote control, its
respective options will appear below.
To use the option, press
B
and
b
on the remote control
to move up and down and press
C
or
c
to select your
desired setting.
Using the TV controls
• To turn on or o the TV, press
1
.
• To alter the volume, press
2
+ or – .
+ and – buttons operate as volume up/down as
default.
When a menu is on-screen, these buttons function as
left/right menu navigation buttons or adjust settings.
• To alter the programme position, press
p B
or
b
.
When a menu is on-screen, these buttons function as
up/down menu navigation buttons.
Please always refer to the owner’s manual of the
equipment to be connected for full details.
NOTE: Interactive video games that involve shooting a
“gun” at an on-screen target may not work with this TV.
Input selection
1
Press
o
on the remote control until the video input
mode list appears on the screen, then press
B
,
b
or
o
to select appropriate input source.
VIDEO2
TV
VIDEO1
Inputs
HDMI
2
Press OK.
TV (analogue aerial input),
VIDEO1 (
o
(1), standard video input),
VIDEO2 (
o
(2), component video input)
HDMI (HDMI input)
BASIC CONTROLS