Instruction Manual

25
About 1 µs
External VD IN*
1
External HD IN*
1
(Internal VD)
Tr igger*
1
About 1H
Negative polarity mode
Positive polarity mode
Exposure period*
2
Exposure period*
2
RGB data
(video interval image)
FVAL
LVAL,
DVAL
28H (
Partial scanning OFF )
24H (
Partial scanning 40fps)
32H (
Partial scanning 50fps)
38H (
Partial scanning 60fps)
42H (
Partial scanning 70fps)
44H (
Partial scanning 80fps)
47H (
Partial scanning 90fps)
The internal VD falling edge is within the
exposure period and thus video is not output.
*
3
*1: Externally input signal
*2: Exposure time is determined by the setting of "7. 2 (1.3) Changing each setting in E.TRG mode".
*3: Video is output at the falling edge of the internal VD following completion of the exposure period.
The video and FVAL/LVAL/DVAL have a paired relationship.
Note:
When the next trigger is input before completion of the output of the video corresponding to the trig-
ger, there will be an effect on the video.
7. 4E. TRG (External trigger)
Charge begins to accumulate after the trigger input to CC1 of the DIGITAL terminal, and 1 frame images are
output. There are four modes: 1P SNR, 1P SR, PW SNR, PW SR.
( 1 ) 1P SNR (1 Pulse Trigger Sync Non Reset)
Charge begins to accumulate after the trigger input to CC1 of the DIGITAL terminal, and 1 frame images are
output.
(1. 1) 1 Pulse Trigger SYNC-NON RESET Picture Output Timing