Toshiba IK-WB11 Camera Installation & Configuration Guide 2 Contents 1 PREREQUISITES....................................................................................................................................................................................... 3 2 CAMERA CONFIGURATION ................................................................................................................................................................. 4 2.1 2.2 2.3 3 SEARCHING AND ENTERING THE CAMERA.
Toshiba IK-WB11 Camera Installation & Configuration Guide 3 This guide explains how to install and configure the Toshiba IK-WB11 camera in the local network. It is strongly recommended that you add only one camera at a time to the network for configuration. 1 Prerequisites Before the configuration begins, check the following: The camera is unpacked and correctly connected to the power source and network. If using a Wired LAN connection, confirm that the network LAN is plugged in.
Toshiba IK-WB11 Camera Installation & Configuration Guide 2 Camera configuration To begin the configuration of the camera you should use the Camera Finder application. Camera Finder is an application for searching network cameras. You can use it by downloading it from the Toshiba website on the following link: http://www.toshiba.com/taisisd/security/support/support_dloads.jsp 2.1 Searching and entering the camera. To configure а camera follow the steps below: 1.
Toshiba IK-WB11 Camera Installation & Configuration Guide 5 3. On this screen click Search button. All cameras, which are currently connected to the network, appear. Make sure that the IP addresses of a camera and computer, which you launched Camera Finder from, are in the same range. 4. Choose the camera you want to login to from the list and click Administrator button to login as administrator. Camera Administrator Login Screen 5.
Toshiba IK-WB11 Camera Installation & Configuration Guide 6 2.2 Network settings configuring Camera Network Settings Screen 1. After you have logged in go to Network Settings->General and enter there the following settings: Specify Camera Name Switch Auto Identification of Other Camera to OFF Switch DHCP to OFF. Specify IP address and Subnet Mask Specify Default Gateway IP address HTTP Port Number leave as default - 80 Contact your system administrator to obtain all required network parameters.
Toshiba IK-WB11 Camera Installation & Configuration Guide 2.3 Administrator credentials configuring To change administrator credentials do the following: 1. Go to Administrator functions->Changing the password. Changing Administrator Credentials Screen 2. Specify current Login ID and Password in the corresponding fields. Default administrator credentials are: Login ID: root Password: ikwb 3. Specify new Login ID 4. Specify new password and confirm it in the corresponding fields. 5. Click Save.
Toshiba IK-WB11 Camera Installation & Configuration Guide 8 3 Advanced camera configuration Quadrox recommends implementing the following settings: 1. Go to Camera Settings->General item. Camera Settings Screen 2. You may not change Camera Picture Size, it is adjustable from WebCCTV software. 3. You may choose Picture Quality you want, but please note higher picture quality consumes more bandwidth. 4. You may not change Frame Rate, it is adjustable from WebCCTV software. 5.
