User`s manual

13
Installation Appendix
Defi nitions in
Confi guration
Introduction
How to Use
In this user's manual, "User" refers to whoever has access to the Network Camera,
and "Administrator" refers to the person who can confi gure the Network Camera and
grant user access to the camera.
Hardware installation
Please verify that your product package
contains all the accessories listed in the
foregoing Package Contents. Depending
on the user's application, an Ethernet
cable may be needed. The Ethernet cable
should meet the specs of UTP Category 5.
Connect the power adapter jack to the Network Camera before plugging in to
the power socket. This will reduce the risk of accidental electric shock.
Upon powering up, the status LED will light up and then the device will go through
a booting process. The status LED will be steady orange when obtaining an IP
address. After obtaining an IP address, the LED will blink orange and red indicating
the camera is ready.
Please refer to the Quick Start Guide for details to the hardware installation.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the
Ethernet cable plug in the power adapter. If the LED turns out to blink orange-color,
go to next paragraph "Software installation".
Power over Ethernet (PoE) installation
Connect the Ethernet cable to a PoE switch or hub and to the camera. The camera
will go through the "power up" sequence. Proceed to "Software installation" after the
camera goes into the ready state.
Installation