User`s manual

6
Installation AppendixDefi nitions in
Confi guration
Introduction
How to Use
NOTES ON USE AND INSTALLATION
This camera is for indoor use.
Do not aim the camera at the sun
Never aim the camera at the sun even with the camera power off .
Do not shoot intense light
Intense light such as a spotlight may cause a bloom or smear. A vertical stripe
may appear on the screen. However, this is not a malfunction.
Treat the camera with care
Do not drop the camera or subject it to intense vibration.
Never touch internal parts
Do not touch the internal parts of the camera other than the parts specifi ed.
Do not splash water on the camera
Install the camera where the camera can be kept dry. If the camera gets wet, turn
off the power and contact your dealer.
Keep the camera installation away from video noise
If cables are wired near electric lighting wires or a TV set, noise may appear in
images. In this event, relocate cables or reinstall equipment.
Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than the
specifi ed operating range. Doing so could aff ect the internal parts or cause the
image quality to deteriorate. Special care is required to use the camera at high
temperature and humidity.
Cleaning the camera
Turn the power off and use a dry cloth to clean the camera. When the dirt is hard
to remove, use a cloth with a mild detergent and wipe gently.
Do not use volatile substances (e.g. paint thinner, petroleum benzin, or household
pesticide) on the camera. Otherwise, it may cause discoloration or malfunctions.
Use a lens cleaning paper (used to clean camera lenses or lenses of spectacles)
to clean the camera lens.
Should you notice any trouble
If any trouble occurs while you are using the camera, turn off the power and
contact your dealer. If you continue to use the camera when there is something
wrong with it, the trouble may get much worse and an unpredictable problem may
occur.
•
•
•
•
•
•
•
•
•
•