Owner manual

44
English
CONTROLS AND FEATURES
To cancel searching for the AP:
Press BACK while searching for the AP. A
message will appear, and then press C
/ c to select
Yes and press
OK.
Assisted Setup
a In the Network menu, press B / b to select
Network Setup and press OK.
b Press B / b to select Wireless Setup and press
OK.
c Press B / b to select Assisted Setup and press
OK.
d Press B / b to select the desired AP and press
OK.
NOTE: Check the MAC address on the label of the
AP or in the manual, and select your AP.
e Highlight Security Key and press OK. The
Software Keyboard window will appear.
f Input the Security Key by using the Software
Keyboard (see page 48). To save your setting,
press the GREEN button.
NOTE:
• The Security Key must adhere to these
conditions:
- AES, AES/TKIP: 8-63 ASCII or 64 Hex
characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex characters
• There is only one key ID to set for WEP
encryption.
g Highlight Done and press OK.
NOTE: If Network Name is not displayed, see
step 3 and 4 in Manual Setup to set Network
Name before pressing Done.
NOTE: Settings are not saved if BACK is pressed before
Done is selected.
Manual Setup
a In the Network menu, press B / b to select
Network Setup and press OK.
b Press B / b to select Wireless Setup and press
OK.
c Press B / b to select Manual Setup and press
OK.
d Press B / b to select Network Name and press
OK. The Software Keyboard window will appear.
e Input the Network Name by using the Software
Keyboard (see page 48). To save your setting,
press the GREEN button.
f Press B / b to select Authentication and press c
and
B / b to select Open System, Shared Key,
WPA2/WPA-PSK (mixed mode WPA2/WPA) or
WPA2-PSK.
g Press B / b to select Encryption and press c
and
B / b to select None, WEP, AES/TKIP or
AES.
NOTE:
• Certain encryption types are only compatible
with specific authentication types.
- When Authentication is Open System, only
WEP or None is compatible.
- When Authentication is Shared Key, only
None and WEP can be selected for
Encryption.
- When Authentication is WPA2/WPA-PSK
(mixed mode WPA2/WPA), only AES/TKIP
can be selected for Encryption.
- When Authentication is WPA2-PSK, only
AES is compatible.
• When incompatible Authentication/Encryption
pairings are detected, a warning message will be
displayed, and no connection attempt will be
made until the incompatibility is resolved.
• There is only one key ID to set for WEP
encryption.
h Press B / b to select Security Key and press OK.
i Input the Security Key by using the Software
Keyboard (see page 48). To save your setting,
press the GREEN button.
NOTE: This item is greyed out when Encryption is
None.
Easy Setup
Assisted Setup
Manual Setup
< Wireless Setup