Cash Register User's Manual

4. READ AND RESET REPORTS
EO1-11110
4-6
CUSTOMER FILE READ
(for Check Track Memory type only)
• All Files Read X
• All Files Reset Z
• Zone Files Read X 15 [#] → |Zone-start File Code|
• Zone Files Reset Z [@/FOR] |Zone-end File Code| [AT/TL]
• Individual File Read X 15 [#] → |File Code| [@/FOR] → [AT/TL]
• Zero-balance Files Read X 15 [#] → 0 [AT/TL]
• Credit-balance Files Read X 15 [#] → 1 [AT/TL]
• Debit-balance Files Read X 15 [#] → 2 [AT/TL]
Report Name Mode Key Operation
Lock
4.2 IN-LINE REPORTS
TABLE OF IN-LINE REPORT OPERATIONS (continued)
RTR Declaration: ON
NOTE: When the “Process Report” is marked, the report can only be taken after taking another report which
consolidates the corresponding data to be based on. For further details, see the table and descriptions
below.
PROCESS REPORTS AND BASE REPORT DATA
The following table shows which process reports are available after which report data collections.
Reports Collection Required before Process
Report takings Process Reports available
(CONSOLIDATION MEMORY CAPTURE: NOTE 1)
All Department Read Daily Individual Department Read Daily
or
All Department Reset Daily
All Department Read GT Individual Department Read GT
or
All Department Reset GT
Any of the following PLU reports (NOTE2) Individual PLU Read Daily
Inactive PLU Read Daily
All PLU Read Daily
Zone PLU Read Daily
All PLU Reset Daily
Zone PLU Reset Daily
Any of the following PLU reports (NOTE2) Individual PLU Read GT
Inactive PLU Read GT
All PLU Read GT
Zone PLU Read GT
All PLU Reset GT
Zone PLU Reset GT
NOTES: 1) CONSOLIDATION MEMORY CAPTURE: When an in-line read or reset report is taken on the
Master Terminal, the consolidated data is automatically stored in the Consolidation Memory of
the Master Terminal. The consolidated data stored there is not only used as the data for a
Process Report but also sent to the PC by a command from the PC when a PC is connected.
2) The process reports will be outputted based on the report data previously collected. For
example, when an “Inactive PLU Read” report is taken after a “Zone PLU Read”, only the inactive
PLUs in the designated zone will be printed on the Inactive Read Report. (Only when the PLU is
in a local file, a process report is printed. In this case, collection of data is required beforehand.)
15 [AT/TL]