Cash Register User's Manual

5. PROGRAMMING OPERATIONS
EO1-11110
5-3
Assign No. of 1 to 16.
1: Master
2: Backup Master
3 to 16: Satellites
5.2.2 TERMINAL ID SETTING (Submode 77)
This submode is available for in-line terminals (including the master and backup master terminals). It must be
operated separately on each terminal since the Terminal ID should vary from terminal to terminal. The data set in
this submode is used as the in-line address of the terminal for in-line service operations.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
77 [@/FOR] |Terminal ID No.| [AT/TL]
NOTE: Be certain not to set the same terminal ID No. to terminals on the in-line system.
If terminals with the same ID No. exist on the in-line system, malfunction may occur.
5.3 VERIFICATION OF PROGRAMMED DATA RELATED TO IN-LINE
SPECIFICATIONS
The programmed data related to in-line specifications can be read for verification purposes. A receipt is issued for
each operation with the programmed data printed.
CONDITION Anytime outside a sale (Sign OFF required under Cashier Signing Method)
OPERATION Mode Lock: X or SET
(RTR Declaration is unnecessary on the Master Terminal.)
• Terminal Connection Table .................169 [AT/TL]
• Terminal ID Setting .............................177 [AT/TL]
NOTES: 1. Verifications listed in the Operator’s Guide of the standalone level are also available on all the
terminals of the in-line system.
2. The verification of Terminal Connection Table can be executed on the Satellite Terminals after
the DLL operation.
ex.) To assign Terminal ID No. 4 to the terminal used as
a Satellite Terminal of the in-line system:
Mode Lock: SET, enter 77, depress [@/FOR].
Enter 4, depress [AT/TL]
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
19-12-1994 MON #1
P77
04
0011 14:16TM
5.3 VERIFICATION OF PROGRAMMED DATA RELATED TO IN-LINE SPECIFICATIONS