Installation Instructions
33
Change of indoor address from wired remote controller
• To change the indoor address in individual operation (Wired remote controller : Indoor unit = 1 : 1) or
group control (When the setup operation with automatic address has finished, this change is available.)
[Procedure] (Operation while air conditioner stops)
1
Push simultaneously
SET
+
CL
+
TES
T
buttons for 4 seconds or more.
(The firstly displayed unit No. indicates the header indoor unit in group control.)
2
In group control, select an indoor unit No. to be changed by
UNIT
button.
(The fan of the selected indoor unit is turned on.)
3
Using the setup temp. / buttons, set 13 to the item code.
4
Using the timer time / buttons, change the displayed setup data to a data which you want to
change.
5
Push
SET
button.
6
Using the
UNIT
button, select the unit No. to be changed at the next time.
Repeat the procedure
4
to
6
and change the indoor address so that it is not duplicated.
7
After the above change, push
UNIT
button to confirm the changed contents.
8
If it is acceptable, push
TES
T
button to finish confirmation.
Operation procedure
1 2 3 4 5 6 7 8
End
3
5
8
1
4
2, 6, 7
ON / OFF
FAN
TEMP.
SWING/FIXTIME
MODE
VENT
UNITSET CL
FILTER
RESET
TEST
TIMER SET
CODE No.
UNIT No.
SETTING
DATA
SET
R.C. No.
6
ADDRESS SETUP