Installation Instructions

Power supply wiring

Item

Model

Wire size

All models of indoor units 2.0 mm² Max. 20m 3.5 mm² Max. 50m

[Indoor unit]

Earth

Earth leakage breaker

Indoor unit

Connection cable

Connector conversion cable

(MMK-AP∗∗∗2H (High Wall) does not use a this conversion cable.)

Indoor control P.C. board

Pulse motor valve (Indoor unit side)

CN82 connector

Pull box

Main switch

Indoor unit power supply

1N~ 50Hz, 220 – 240V

1N~ 60Hz, 220V

PMV

PMV Kit

For Indoor unit power supply (The outdoor unit has a separate power supply.)

Note)

• Power supply cord specification : Cable 3-core 2.5 mm², inconformity with Design 60245 IEC57.

• The connecting length indicated in the table represents the length from the pull box to the outdoor unit when the

indoor units are connected in parallel for power, as shown in the illustration below. A voltage drop of no more than

2% is also assumed. If the connecting length will exceed the length indicated in the table, select the wire

thickness in accordance with indoor wiring standards.

• Determine the wire size for indoor unit according to the number of connected indoor units downstream.

For details of the PMV Kit, refer to the Installation Manual.

Connection of PMV Kit