Manual

[] When shipping the unit, the original shipping carton and
packing materials come in handy. For fully protection,
repack the unit as it was originally packed at the factory.
[] Do not use volatile liquids, such as insect spray, near
the unit. Do not leave rubber or plastic products in
contact with the unit for a long time. They will leave
marks on the finish.
[] The top and rear panels of the unit may become warm
after a long period of use. This is not a malfunction.
[] When the unit is not in use, be sure to remove the disc
and turn off the power.
[] If you do not use the unit for a long period, the unit may
not function properly in the future. Turn on and use the
unit occasionally.
Moisture condensation damages the unit. Please
read the following carefully.
Moisture condensation occurs, for example, when you
pour a cold drink into a glass on a warm day. Drops of
water form on the outside of the glass. In the same way,
moisture may condense on the optical pick-up lens inside
this unit, one of the most crucial internal parts of the unit.
®
[] Place the unit on a level surface. Do not use it on a
shaky or unstable surface such as a wobbling table
or inclined stand. The loaded disc may come off the
proper position and cause damage to the unit.
[] When you place this unit near aTV, radio, or VCR, the
playback picture may become poor and the sound may
be distorted. In this case, place the unit away from the
TV, radio or VCR.
1
Use a soft, dry cloth for cleaning.
® For stubborn dirt, Do not use any type of solvent,
such as thinner and benzine, as they may damage the
surface of the unit.
® If you use a chemical saturated cloth to clean the unit,
follow that product's instructions.
Moisture condensation occurs during the
following cases.
[]
® When you bring the unit directly from a cold place to a
warm place.
® When you use the unit in a room where you just turned
on the heater, or a place where the cold wind from the
air conditioner directly hits the unit.
® In summer, when you use the unit in a hot and
humid place just after you move the unit from an air
conditioned room.
® When you use the unit in a humid place.
®
[] Do not use the unit when moisture condensation
may occur.
Ifyou use the unit in such a situation, it may damage
discs and internal parts. Remove the disc, connect the
power cord of the unit to the wall outlet, turn on the unit,
and leave it for two or three hours. After two or three
hours, the unit will have warmed up and evaporated any
moisture. Keep the unit connected to the wall outlet and
moisture condensation will seldom occur.
Wall outlet
I
6
5Y80 01Aindb 6
÷
12'152006 12:21:16 PM