Operation Manual
30
INSTALLATION MENU
ITEM SETTING FUNCTION
LANGUAGE --------- -5言語 ------------ Selects a language used for displays on the screen, such as
menus. Adjusts computer video images.
RGB & COMPONENT ---------------- Adjusts computer video images.
AUTO * --------------------------------------- Selecting Auto and pressing ENTER button automatically
adjust position and size of the projected images in
accordance with the image signals from the computer.
FREQUENCY *−15∼+15-------- If any wide streak pattern appears on the projected images, it
can be adjusted with this setting while viewing the images.
PHASE *------------ 0 ∼ 31 ----------- If any flicker or blur appears on the projected images, it can be
adjusted with this setting while viewing the images.
H.POS * --------- −30 ∼ +30 ------- Moves display position of projected images in horizontal
direction.
V. POS * --------- −30 ∼ +30-------- Moves display position of projected images in vertical direction.
MIRROR ------ FLOOR FRONT ----- Select this setting with the projector set on the floor when
viewing the projected images from the front side.Normally,
select this setting.
---------- CEILING FRONT ---- Select this setting with the projector suspended from the
ceiling when viewing the projected images from the front side.
------------ FLOOR REAR ------ Select this setting with the projector set on the floor when
viewing the projected images from the rear side of the screen.
----------- CEILING REAR ----- Select this setting with the projector suspended from the
ceiling when viewing the projected images from the rear side
of the screen.
KEYSTONE --- −12∼+12-------- Select this setting when correcting trapezoidal distortion.
Normally, select “0”.
PATTERN ----------------------------------- Pressing ENTER button reveals the test pattern for focus
adjustment.
• The items with * mark function only for 1080i, 720p, 525p, and 625p input signals and input signals from DVI terminal.
• The varying range of the vertical position depends on the type of the input signal. With some values the vertical position may not
change, but this is not a failure.
• With the inputs from DVI-DIGITAL terminal, no change appear on the projected images with adjustment of the dividing ratio and
fine, but this is not a failure.
• Without input signals, only some of the above items can be changed.
INSTALLATION...
RGB & COMPONENT
MIRROR
KEYSTONE
PATTERN
LANGUAGE
RGB & COMPONENT
INSTALLATION...
FREQUENTCY
AUTO YES?
PHASE
H. POS
V. POS
0
15
0
0
DIASPLAY MENU
On the memory for projected image quality
This projector allows each item in the picture quality setting menu and the professional-use picture quality
setting menu (except for color temperature use-adjustment) to be adjusted to up to three kinds of favorable
picture quality for each input signal.
Input that allows the setting Number of settings
VIDEO 3
S-VIDEO 3
COMPONENT 1, 2 3
DVI-ANALOG/DIGITAL 3
To store the settings:
(Refer to Page 25 for how to set menus.)
1. Set an item in the picture quality setting menu and the professional-use picture quality setting menu.
2. Reveal the signal setting menu.
3. Select “Store the setting “ by pressing {, } buttons.
4. Press ENTER button.
The setting storage menu appears.
5. Select the memory where the setting is to be stored by pressing {, } buttons.
6. Press ENTER button.
The setting is stored in the memory.
To cancel the menus:
7. Press MENU button.
To apply the set picture quality:
1. Press MEMORY1, 2, or 3 button.
The picture quality of the projected image comes to the set quality.
INSTALLATION...
MEMORY 2
MEMORY 3
MEMORY 1
SAVE
SETTING WITH MENUS