Operation Manual

Menus
27
English
3. Color: Increases or decreases the color intensity of the image. The higher the value, the more
vivid and brighter the color.
4. Tint: Adjusts the color tones of the image. The higher the value, the more greenish the picture
becomes. The lower the value, the more purplish the picture becomes.
5. Filter: Turns the video and data filters on or off. Filters can reduce picture noise to produce a
sharper image. The higher the setting, the less the noise.
6. Sharpness: Adjusts the picture sharpness. The higher the number, the sharper the picture.
7. Extended Picture Setting
Q Color Temp: You can choose a preferred color temperature from among Lamp Native, Warm,
Middle, Cool, User 1, and User 2. Refer to for more information about storing the color
temperature to User 1 and 2.
Q Color Enhancement
Red: Adjusts red hues independently. The higher the setting, the greater the intensity of red
color in the image.
Green: Adjusts green hues independently. The higher the setting, the greater the intensity of
green color in the image.
Blue: Adjusts blue hues independently. The higher the setting, the greater the intensity of blue
color in the image.
Yellow: Adjusts yellow hues independently. The higher the setting, the greater the intensity of
yellow color in the image.
White: Adjusts white peaking.
8. Save Settings: There are three video memories in which users can store settings, including all
of the items in the Picture menu. Each input source can store up to 3 sets of User Memories.
Q To store the settings:
i.) Adjust the items in the Picture menu to your desired values.
ii.) Select Save Settings and then press .
iii.) Select To User’s Memory 1, To User’s Memory 2, or To User’s Memory 3 and press to store
the settings.
iv.) To close the OSD, press MENU.
9. Load Settings: Loads the settings from one of three User Memories or one of four default
settings (Dynamic, Standard, Theater 1, or Theater 2).
Display menu
Use this menu to set the way that the projector displays the picture.
1. Screen Size: Selects the aspect ratio for displaying different video signals.
2. PIP: Selects a second input signal for displaying a second image.
3. POP: Selects a second input signal for displaying a second image.
4. PIP/POP Source Swap: Toggles the active window between the two images. (You can make
adjustments to the active window only.)
5. PC Tuning: The following settings are only available when a PC or RGB signal is selected.
Q Frequency: Adjusts the frequency of the sampling clock that captures the input signal.
Q Phase: Adjusts the phase of the sampling clock.
Q H. Position: Adjusts the horizontal position of the image.
Q V. Position: Adjusts the vertical position of the image.
Q Auto: Adjusts the phase, and frequency automatically.
p.29
p.22