User Manual

2 SETTING ITEMS (ADMIN)
96 Setting General Functions
2
Press [DEFAULT] to set the default calibration setting, or [CALIBRATION] to adjust the
calibration setting.
y When you press [DEFAULT], the system maintains the default calibration setting and returns to the previous
screen.
y When you press [CALIBRATION], a chart is printed out and the calibration guide illustration is displayed on the
touch panel.
Proceed to the next step.
3
Place the printed chart face down on the glass, so that the two black rectangular marks
are placed on the left side.
4
Press the [START] button on the control panel.
The calibration begins. Do not operate the equipment until the message “Scanning and calibrating” disappears.
If the chart is not properly placed, the message “Set chart correctly” is displayed on the touch panel. In this
case, return to step 3 and realign the chart.