Maintenance Manual

4.10 Display Assembly 4 Replacement Procedures
4.10 Display Assembly
Removing the Display Assembly
The following describes the procedure for removing the display assembly (See Figure 4-24 to
4-26).
1. Open the display and disconnect the LCD cable from PJ5600 on the system board.
2. Pull out the insulator covering the speaker connectors from the chassis and turn up the
insulator. Disconnect the speaker cables (Blue, Red) from PJ6000 and PJ6001
respectively.
PJ6000
LCD Cable
PJ5600
Left Speaker Cable
(Blue)
PJ6001
Right Speaker Cable
(Red)
Insulator
Figure 4-24 Removing Display Assembly (1)
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445) 4-35