Maintenance Manual

4.5 Display Assembly 4 Replacement Procedures
4.5 Display Assembly
Removing the Display Assembly
Remove the display assembly according to the following procedures and Figures 4-7.
1. Open the display panel at an angle of 90 degrees.
2. Turn the computer upside down.
3. Disconnect the CCD cable from CN2250 on the system board.
4. Disconnect the MIC cable from CN208 on the system board.
5. Disconnect the LCD cable from CN3000 on the system board.
6. Remove two M2.5x4 black flat head screws securing the LCD module to the top
cover.
CN2250
CN208
CN3000
M2 5x4 black flat head screw.
LCD cable
MIC cable
CCD cable
Figure 4-7 Removing the display assembly
Satellite/E200/E205 Maintenance Manual 4-17