User Guide

4 Replacement Procedures 4.12 Bluetooth / LE board
4.12 Bluetooth / LE board
4.12.1 Bluetooth
Removing a Bluetooth
The following describes the procedure for removing a bluetooth (See Figure 4-25).
1. Remove the following screw securing a bluetooth module.
• M2.0×4.0Z BIND screw x1
2. Disconnect the blutooth flat cable from a bluetooth module.
3. Remove a bluetooth module from the cover assembly.
M2.0x4.0Z BIND
Bluetooth module
Bluetooth flat cable
Figure 4-25 Removing a bluetooth module
Installing a Bluetooth
The following describes the procedure for installing a bluetooth (See Figure 4-25).
1. Connect the bluetooth flat cable to the connector on a bluetooth module.
2. Install a bluetooth module to the cover assembly and secure it with the following
screw.
• M2.0×4.0Z BIND screw x1
QOSMIO G10 Maintenance Manual (960-497) 4-39