User Guide

4.19 Speaker (R) / TJ board 4 Replacement Procedures
3. Arranging the TJ board cable along the guide, connect it to the connector CN9614
on the TJ board.
4. Arrange the USB harness along the guide.
TJ board cable
USB harness
Figure 4-39 Cable arrangement in guide
5. Install the harness holder and secure it with the following screw.
• M2.5×4.0B FLAT BIND screw x1
NOTE: When installing the harness holder, be careful not to catch cables.
6. Arrange the DC-IN cable along the guide of harness holder and install the DC-IN
jack in the slot of base assembly.
7. Fix the DC-IN cable with the glass tape.
4-58 QOSMIO G10 Maintenance Manual (960-497)