User Guide

2 Troubleshooting Procedures 2.4 System Board Troubleshooting
Table 2-6 Debug port (Resume mode) error status (4/4)
LED status Test item Contents
(12Ah)
Final decision of USB FDD information
Post-process of PRE_BOOT_SETUP
Clears PWRBTN_STS.
Enables Power Button.
Measures against chip set defective
Waiting for the completion of recovery of
VGA register
Recovery of PIT register
Recovery of PCI configuration register
Recovery of PIC MASK
Executing of driver for RESUME
Waiting for FDD recovery completion (for
models supporting built-in FDD)
Checks if the power-off switch is pressed
or not during resume processing
(Suspends if pressed)
F12Bh
Executes HOTKEY F1 processing when
booting in instant security
F12Ch
(Not in ACPI mode) Clears key buffer
F12Dh
(In ACPI mode) Clears IRT status
F12Eh
(In ACPI mode)
Clears flag in Resume process
Acquires Wake Up Vector address.
Clears key buffer.
Update of date/time
ACPI mode on
Recovery of write-protected status
before.
FFFFh (In ACPI mode / not in ACPI mode)
Initialization of printer port (for models
supporting printer)
Returning to the main process
NOTE: Status outputted by the test means the last error detected in the debug port test.
QOSMIO G10 Maintenance Manual (960-497) 2-35