Instructions / Assembly

CONTENTS Warning
2
3
4
5
6
7
8
9
10
1
CAUTIONS
This
Changes or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
device complies with Part 15 of the FCC Rules
and RSS 210 of Industry & Science Canada. Operation
is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Only operate the device in accordance with the
instructions supplied. This device complies with FCC
and IC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the
possibility of exceeding the FCC and IC radio frequency
exposure limits, human proximity to the antenna shall
not be less than 20cm (8 inches) during normal operation.
Changes or modifications not expressl
y approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
DECLARATION OF CONFORMITY........................ 1
SPECIFICATION................................................... 1
PRECAUTIONS ....................................................1
SYSTEM OVERVIEW ............................................2
DOWNLOAD AND INSTALL THE APP ...................3
CREATE YOUR ACCOUNT ...................................4
SET UNIT TO ACCESS POINT MODE ................... 6
NETWORK CONFIGURATION................................7
HOW TO USE THE APP........................................20
SPECIAL FUNCTIONS..........................................22
User Manual User Manual