Full Product Manual

User Manual Page 9
WATER DRAINAGE cont.
• During heating mode, remove the lower drain plug from the
back of the unit and install the drain connector (5/8” universal
female mender) with 3/4” hose (locally purchased). For models
without drain connector, just attach the drain hose to the
hole. Place the open end of the hose adaptor directly over the
drain area in your basement  oor.
Operating
Instructions
• When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times. The digital
display shows “P1.” At this time the air conditioning/
dehumidi cation process will immediately stop. However, the
fan motor will continue to operate (this is normal). Carefully
move the unit to a drain location, remove the bottom drain
plug and let the water drain away. Reinstall the bottom drain
plug and restart the machine until the “P1” symbol disappears.
If the error repeats, call for service.
NOTE
Be sure to reinstall the bottom drain plug  rmly to prevent
leakage before using the unit.
NOTE
Make sure the hose is secure so there are no leaks. Direct the hose
toward the drain, making sure that there are no kinks that will
impede water  ow. Place the end of the hose into the drain and
make sure the end of the hose is directed downward to let the
water  ow smoothly. (See Figs with ).
Installation not recommended. (See Figs with
X
). When the
continuous drain hose is not used, ensure that the corresponding
drain plug and knob are installed  rmly to prevent leakage.
¥
Drain hose
adaptor
Continuous
drain hose
Remove the
lower drain
plug
Units with
Pump Only
X
Drain hose
adaptor
Press the power
cord buckle into
the rear cover.
Drain
hose
adaptor
¥
Delivery lift <1.8m
Units with Pump Only