Use and Care Manual

Page 10 User Manual
Operating
Instructions
Operating Instructions
COOL operation
• Press the “MODE” button until the “COOL” indicator
light comes on.
• Press the ADJUST buttons Up (
) or Down ( ) to select
your desired room temperature. The temperature can be
set within a range of 60°F~86°F/16°C~30°C.
• Press the “FAN SPEED” button to choose the fan speed.
HEAT operation
• Press the “MODE” button until the Heat “ ” indicator
light comes on.
• Press the ADJUST buttons Up (
) or Down ( ) to select
your desired room temperature. The temperature can be
set within a range of 60°F~86°F/16°C~30°C.
• Press the “FAN SPEED” button to choose the fan speed.
• When entering heat mode, the fan may start slower
than expected. This is normal operation to allow the
unit to begin heating e ectively. After a few minutes
the unit should reach your desired fan speed.
DRY operation
• Press the “MODE” button until the “DRY” indicator light
comes on.
• While in this mode, you cannot select a fan speed or adjust
the temperature. The fan motor operates at LOW speed.
• Keep windows and doors closed for the best
dehumidifying e ect.
AUTO operation
• When you set the air conditioner to AUTO mode, it
will automatically select cooling, heating or fan only
operation depending on what temperature you have
selected and the current room temperature.
• The air conditioner will control room temperature
automatically according to the temperature point set
by you.
• Under AUTO mode, you cannot select the fan speed.
FAN operation
• Press the “MODE” button until the ”FAN“
indicator light comes on.
• Press the “FAN SPEED” button to choose
the fan speed. The temperature cannot be
adjusted.
• Do not connect the duct to a window.
TIMER: Auto Start/Stop Operation
• When the unit is on, pressing the Timer
button will initiate the Auto stop program.
The TIMER OFF indicator light illuminates.
Press the Up ( ) or Down ( ) button to
select the desired time. Press the TIMER
button again within 5 seconds. The Auto
start program is initiated and the TIMER ON
indicator light illuminates. Press the Up ( )
or Down ( ) button to select the desired
Auto start time.
• When the unit is o , press the Timer button
to initiate the Auto start program. Pressing
it again within  ve seconds will initiate the
Auto stop program.
• Press or hold the Up (
) or Down ( )
button to change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will
count down the time remaining until start.
• The system will automatically revert back to
display the previous temperature setting if
there is no operation within 5 seconds.
• Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop timer program.
• Should a malfunction occur, the Auto Start/
Stop timed program will also be cancelled.
Shows Error codes and protection code:
E1 - Room temperature sensor error.
E2 - Evaporator temperature sensor error.
E3 - Condenser temperature sensor error (select models).
E4 - Display panel communication error.
P1 - Bottom tray is full - Connect the drain hose and drain
the collected water away. If protection code repeats,
call for service.
When one of these error codes occurs,
turn off the unit and check for any
obstructions. Restart the Unit. If the
malfunction persists, turn off the unit
and unplug the power cord and contact
customer service at 1-855-204-5313.
NOTICE