Use and Care Manual

Page 16 User Manual
Foam seal B
(Adhesive
type-shorter)
Foam seal A
(Adhesive
type)
Window slider A
Window slider B
(if required)
Installation
Instructions
Type 2: Sliding window Installation (Optional)
1. Cut the adhesive foam seal A and B strips to the proper
lengths, and attach them to the window sash and frame as
shown.
2. Assembling the Sliding Window Adapter (Only needed
for Sliding Window applications): Align both halves of the
sliding window adapter and connect them. Then, attach
the air divider to the newly formed window adapter on the
outdoor side. The fully assembled adapter should look like
the image at the left.
3. Insert the window slider assembly into the window track. If the
hose opening is covered by the window frame, rotate the panel
so the thicker side faces the window frame. Attach the Window Kit
Brace to the back of the hose panel to brace against the window
so the window slider panels do not lean inward.
4. Be sure bolts are installed in both sides of the window slider for
improved rigidity.
Window
Kit Brace
Foam seal C
(Non-adhesive type)
5. Cut the non-adhesive foam seal C strip to match the
window height. Insert the foam seal between the glass and
the window frame to prevent air and insects from getting
into the room.
Sliding
Window
Adapter
(Front + Rear)
Air
Divider