Use and Care Manual

Page 20 User Manual
TROUBLESHOOTING TIPS
Troubleshooting
Tips
Before calling service, review this list. It may save you time and expense. This list includes common
occurences that are not the result of defective workmanship or materials of this appliances.
NOTICE
Do not add extension to the exhaust hose(s)!
Problem Solution
Unit does not turn on
when pressing ON/
OFF button
Displays P1 Error Code and means the water collection tray is full. Turn o the unit,
drain the water from the water collection tray, and restart the unit.
If room temperature is lower than the set temperature in COOL mode, reset the
temperature.
Unit does not cool
well
The air  lter is blocked with dust or animal hair. Turn o the unit and clean the  lter
according to the instructions.
Exhaust hose is not connected or is blocked. Turn o the unit, disconnect the hose,
check for blockage and reconnect the hose.
Temperature setting is too high; decrease the set temperature.
Make sure all windows and doors are closed.
The room area could be too large; doublecheck the cooling area.
Check the room for possible heat sources and remove them if possible.
The unit is noisy and/
or vibrates too much
The  oor is not level. Place the unit on a  at, level surface.
The air  lter is blocked with dust or animal hair. Turn o the unit and clean the  lter
according to the instructions.
The unit makes a
gurgling sound
This sound is caused by the refrigerant  ow inside the unit and is normal.
Unit will not connect
to Wireless or App
does not work (some
modesl)
For additional support and troubleshooting tips,
follow the link in the QR code:
The top of the window
kit leans forward out of
the window track
Ensure the Window Kit brace is installed properly.
In heating mode, the
fan speed is lower than
expected.
It is normal for the fan speed to start low in heating mode. The fan speed should
reach your desired setting after a few minutes of operation.
Condensation collects
on the outer section of
the hose in heat mode
Apply the included hose insulation foam as shown on the next page.