Use and Care Manual

User Manual Page 9
Operating
Instructions
Control Panel Features
Swing Button
Used to initiate the Auto Swing feature. When the
operation is ON, pressing the SWING button can
stop the louver at the desired angle.
Connect Button
The swing button is also used to initiate the wireless
connection mode.To initiate the wireless connection
mode, power on the air conditioner then press
the SWING button for 3 seconds. The LED DISPLAY
will show ‘AP’ to indicate the unit is in wireless
connection mode. Refer to the app connection
instructions to finish the connection process.
If the connection is successful, the unit will exit
wireless connection mode and illuminate the
wireless LED. If the connection fails, the unit will
exit wireless connection mode automatically after 8
minutes and the wireless LED does not illuminate.
Note: The wireless connection process must be
completed within 8 minutes after powering the air
conditioner on.
Timer button
Used to initiate the AUTO ON start time and AUTO
OFF stop time program. The timer on or off light will
illuminate depending on the selected setting. See
page 10 for more detailed instructions
Fan button
Controls the fan speed. Press to control the fan speed in
four steps - LOW, MID, HIGH and AUTO. The selected fan
speed light (except AUTO) will illuminate.
NOTE: Applicable to models with the Constant Fan
feature. In COOL or DRY mode, press the Fan button for
3 seconds to turn on or o the constant fan function.
When the function is turned on, the constant
fan light will illuminate, indicating the fan will
run constantly.
When the function is turned off, the constant
fan light will go out, indicating that the fan will
stop when the compressor stops.
Mode button
Selects the desired operating mode. Each time
you press the button, a mode is selected in a
sequence that goes from AUTO, COOL, DRY,
FAN and HEAT. The mode light illuminates and
indicates the selected mode.
Up ( ) and Down ( ) buttons
Used to increase/decrease temperature
settings in 1° increments in a range of
60°F/16°C to 86°F/30°C or the TIMER setting in
a range of 0 ~ 24hrs.
To change between °F or °C, simultaneously
press and hold the Up and Down buttons for
3 seconds.
Power button
Powers the unit on and off.
Sleep button
Used to initiate the SLEEP operation.
LED display
Shows the set temperature in °F (Degrees
Fahrenheit) or °C (Degrees Celsius) and the
Auto-timer settings. While on DRY and FAN
modes, it shows the room temperature.
Swing (Connect)
Button
Up (
) and Down ( )
Buttons
Mode
Button
Power Button
Sleep
Button
Fan
Button
Timer
Button
LED DisplayWireless Indicator