Full Product Manual

Page 20 User Manual
Installation
Instructions
1. Check window opening size - the mounting parts furnished with
this air conditioner are made to install in a wooden sill double-
hung window. The standard parts are for window dimensions
listed above. Open sash to a minimum of 19” (483 mm). See Fig. D.
2. Check condition of window - all wood parts of window must be
in good shape and able to  rmly hold the needed screws. If not,
make repairs before installing unit.
3. Check for anything that could block air ow - check area outside
of window for things such as shrubs, trees, or awnings. Inside, be
sure furniture, drapes, or blinds will not stop proper air ow.
4. Check the available electrical service - Power supply must be the
same as that shown on the unit serial nameplate. Power cord is 48
in long. Be sure you have an outlet nearby.
5. Carefully unpack air conditioner - Remove all packing material.
Protect  oor or carpet from damage. Two people should be used
to move and install unit.
SASH
Storm Window Frame
or Other Obstruction
19” MIN.
1/2” MIN.
Fig. D
Preliminary Instructions (cont.)
Hardware (Packed with the unit)
7/16” Locking screw and Flat
washer for window
panels
2 ea.
3/4” (or 1/2”) Long
Hex-head Screw
7
Safety Lock 1
1/2” Long screw
and Locknut
4 ea.
3/4” Long Flathead Bolt
and Locknut
2 ea.
Sill Angle Bracket 2
Long hex-head locking screw
for top rail, side retainer
5/16” Length
10
Foam insert 2
Window sash seal foam 1
R1 hardware 2
Weather stripping
(10” *3/4” *1/12” )
5
NOTE
R1 hardware and weather stripping is for
ENERGY STAR models only.
Tools Required
A large  athead screwdriver, Tape measure,
Adjustable wrench or pliers, Pencil, Level, Socket
wrenches, Phillips screwdriver