Use and Care Manual

Page 22 User Manual
Installation
Instructions
1. Check window
opening size - the
mounting parts
furnished with this
air conditioner are
made to install in a
wooden sill double-
hung window. The
standard parts
are for window
dimensions listed
above. Open sash to
a minimum of 19”
(483 mm). See Fig. D.
Do the following before starting to install unit.
See illustrations below. Check dimensions of
your unit to determine model type:
Unit Height: 18-5/8” 17-5/8”
Unit Width: 26-1/2” 23-5/8”
Min. Window Opening: 19-1/2” 18-1/2”
Min. Window Width: 31” 28”
Max. Window Width: 42” 40-1/2”
Preliminary Instructions
WARNING - Before You Begin
Read these instructions completely and
carefully.
• IMPORTANT - Save these instructions for local
inspector’s use.
• IMPORTANT - Observe all governing codes
and ordianaces.
• Note to Installer - Be sure to leave these
instructions with the consumer.
• Note to Consumer - Keep these instructions
for future reference.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Completion time - Approximately 1 hour.
We recommend that two people install this
product.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is
not covered under the Warranty.
You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
CAUTION
• Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
• Do not change the plug on the power cord of
the air conditioner.
• Aluminum house wiring may present special
problems - consult a quali ed electrician.
• When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum  ns on
front and rear coils.
NOTE
Save Carton and these Installation Instructions
for future reference. The carton is the best way
to store unit during winter, or when not in use.
Window Sash Seal
Top AngleFoam Gasket
3/4” Long Flat Head Bolt Sill Angle Bracket
1 /2 Long
Screw and
Locknuts
Window
Support Bracket
Frame
Assembly (Right)
Side Retainer
Washer Head
Locking Screw
Bottom Rail
Seal to Unit
Frame
Assembly
(Left)
Safety Lock and
3/4“ (or 1/2” ) Long
Hex Head Screw
Locknuts
SASH
Storm Window Frame
or Other Obstruction
19” MIN.
1/2” MIN.
Fig. D
Installation Instructions (only WK15 / WK18 models)