Use and Care Manual

User Manual Page 23
Installation
Instructions
Preliminary Instructions (cont.)
Hardware (Packed with the unit)
2. Check condition of window - all wood parts
of window must be in good shape and able
to  rmly hold the needed screws. If not, make
repairs before installing unit.
3. Check your storm windows - if your storm
window frame does not allow the clearance
required, correct by adding a piece of wood as
shown in Fig. E, or by removing storm window
while room air conditioner is being installed.
4. Check for anything that could block airflow
- check area outside of window for things
such as shrubs, trees, or awnings. Inside, be
sure furniture, drapes, or blinds will not stop
proper airflow.
5. Check the available electrical service - Power
supply must be the same as that shown on the
unit serial nameplate. Power cord is 48 in long.
Be sure you have an outlet near.
6. Carefully unpack air conditioner - Remove all
packing material. Protect  oor or carpet from
damage. Two people should be used to move
and install unit.
SASH
19” MIN.
Storm Window Frame
or Other Obstruction
Board Thickness as
Required, Along
Entire Stool. Fasten
With Two Nails Or Screws.
1/2” MIN.
1/2” MIN.
Fig. E
7/16 in Locking screw and
Flat washer for window
panels
2 ea.
3/4 in (or 1/2 in) Long
Hex-head Screw
7
Safety Lock 1
1/2 in Long screw
and Locknut
4 ea.
3/4 in Long Flat Head Bolt
and Locknut
2 ea.
Sill Angle Bracket 2
Long hex-head locking screw
for top angle, side retainer
5/16 in Long
10
Foam insert 2
Window sash seal foam 1
R1 hardware 2
Weather stripping
(10 in *3/4 *1/12 in )
5
NOTE
R1 hardware and Weather stripping is only for
Energy star models.
Tools Required
A large  at blade screwdriver; Tape measure;
Adjustable wrench or pliers; Pencil; Level; Socket
wrenches; Phillips Screwdriver