Use and Care Manual

Page 28 User Manual
Installation
Instructions
3/4” (or 1/2” )
long Hex-head
screw
Fig. 17A
4. Attach the top angle to window frame: Use
a 3/32 drill bit to drill one hole through the
hole in the middle of top angle into the
window frame, and drive one 3/4” (or 1/2”)
HEX-HEAD locking screw through hole in the
middle of top angle into the window frame
as shown (Fig. 17A).
Fig. 18A
A. 3/4” (or 1/2”) Long Hex Head Screw
B. Left-Hand Window Filler Panel Top Leg
C. Window Channel
Window Channel
A
B
C
Wheather seals
A. 3/4” (or 1/2”) long hex head screw
A
Fig. 18B
7 Attach Window Filler Panels to Window Frame
1. Extend the window  ller panels out against the
window frame.
2. Use a 1/8 in drill bit to drill a starter hole
through the hole in the top leg of each window
 ller panel and into the window sash (Fig. 18A
and Fig. 18B). Connect with one 3/4” (or 1/2”)
long hex head screw.
Window Sash
Seal
Fig. 18
8 Install Window Sash Seal and
Safety Lock
1. Trim sash seal to fit window
width. Insert into space between
upper and lower sashes (Fig. 18).
2. Attach right angle safety lock
(Fig. 19).
Safety Lock
3/4” (or 1/2” )
Long
Hex-head
Screws
Fig. 19