Use and Care Manual

User Manual Page 35
Handling the Remote Controller
Installation Instructions of Battery
REMOTE CONTROL OPERATING INSTRUCTIONS
Location of the remote controller
• Use the remote controller within a distance of 5 meters from
the appliance, pointing it towards the receiver. Reception is
con rmed by a beep.
5m
• The air conditioner will not operate if curtains, doors or other
materials block the signals from the remote controller to the unit.
• Prevent any liquid from falling into the remote controller. Do
not expose the remote controller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to
direct sunlight, the air conditioner may not function properly.
Use curtains to prevent the sunlight from falling on the
receiver.
• If other electrical appliances react to the remote controller,
either move these appliances or consult your local dealer.
CAUTIONS
Step 1: Insert a coin vertically in the groove
on the battery cover, clockwise rotation of 45
degrees, make sure that the groove is aligned
with the “unlock” sign as shown below and
remove the battery cover.
Step 3: Install the battery cover, make sure the
battery cover groove is aligned with the “unlock”
sign. Insert a coin vertically in the groove and press
it gently, then counter clockwise rotation of 45
degrees, make sure the groove is aligned with the
“lock” sign as shown below.
Step 2: Install battery inside the remote controller,
the positive (+) side up.
Coin
Battery
cover
Battery
cover
Groove
Lock
sign
Unlock
sign
Unlock
sign
Groove
Lock sign
Coin
Battery
Positive (+) side up
Coin
Groove
Battery cover
Unlock sign
Lock sign
Coin
Groove
Battery cover
Unlock sign
Lock sign
WARNING
1. Battery must be disposed of properly. Do not
short circuit or dispose of in the  re.
2. Keep batteries out of the reach of children.
3. Caution for ingestion.
4. Non-rechargeable batteries are not to be
recharged.
5. Exhausted batteries are to be removed from
the product.
Operating
Instructions
(With Remote)