Use and Care Manual

User Manual Page 29
Installation
Instructions
Fig. 21
or
Fig. 22
9 Install Chassis into Cabinet and Install Front to Unit
1. Lift air conditioner and carefully slide into cabinet leaving 6 in protruding.
2. DO NOT push on controls or  nned coils.
3. Be sure chassis is firmly seated towards rear of cabinet.
4. Installation of front is the reverse of removal outlined in Section 1.
10 INSTALL R1 HARDWARE (only be applicable to Energy star
models)
In order to minimize air leaks and ensure optimal insulation, it is
necessary to install the included R1 hardware to the side curtain.
Follow the instructions below.
Step 1. After the unit is installed to the window, measure the inner
width of the side curtain as shown (Fig. 20).
Step 2. Remark a line on the provide R1 insulation panel
according to a length 1/8” (3 mm) less than the
measured width in step 1, then cut the R1 insulation
panel along the line (Fig. 21).
Step 3. Slide the R1 insulation panel into the side curtain, the side
with pattern should facing the indoor side. (Fig. 22).
Step 4. Repeat on the other side.
Measure the inner width
of the side curtain
Fig. 20