Use and Care Manual

Page 14 User Manual

Installation

Instructions

C. Align the hole in the top rail

with those in the top of the

unit as shown in Fig. B.

D. Secure the top rail to the

unit with the 3/8” Screws as

shown in Fig. C.

Fig. 1

A. Place unit on floor, a bench or a table. Hold the Accordion

Panel in one hand and gently pull back the center to free the

open end. See Fig. 1.

Fig.B

Fig.C

NOTE

For safety reasons, all four

(4) screws MUST be securely

fastened.

RAC-WK05 Models

RAC-WK06/08/10/12/15/18 Models

3. Install the Accordion Panels on Air Conditioner

NOTE

The top rail hardware and the Fig. A, Fig. B and Fig. C are not applicable to the units with more than 10000 Btu/h.

Before installing unit, the top rail must be assembled on the unit (For < 10000 Btu/h models only).

Top rail and Sliding Panels at each side are o set to provide the proper pitch to the rear of (5/16”).

This is necessary for proper condensed water management and drainage. If you are not using the

Side Panels for any reason, this pitch to the rear must be maintained.

Fig. C

Fig. B

Fig. C

Fig. B