Instructions / Assembly

User Manual Page 9
7. SET UNIT TO ACCESS POINT MODE
Connect the unit to power supply, press and hold VENT ANGLE /SWING (on Portable
AC) or WIFI/WIRELESS (on Window AC) buttons for 3-5 seconds. The unit will enter
Access Point mode and the display will show “AP”. Proceed to the next step.
NOTE
On units which include a remote control with an “LED” button, you can also
use the remote controller by pressing the LED button 7 times.
NOTE
When the unit is in “AP” / Access Point mode, the remote controller is inactive. It
is necessary to  nish the network con guration, turn the AC o and on again or
wait for 8 minutes for the unit to leave “AP” mode automatically.